Idle Control System

...

DTC Troubleshooting

DTC P0506: idle Control System RPM Lower Than Expected NOTE: Before you troubleshoot record all freeze data and any on-board snapshot, and review the general troubleshooting information (see page ...

See also:

Selector Control Shaft Oil Seal Replacement
Special Tools Required -Driver Handle, 15 x 135L 07749-0010000 •Attachment 22 x 24 mm 07746-001A800 1. Remove the oil seal (A) from the end cover (B). 2. Install a new oil seal flush to the ...

Ignition Key Switch Test
1. Remove the steering column upper and lower covers (see page 20-181). 2. Disconnect the 6P connector (A). 3. Check for continuity between terminals No. 1 and No. 2. • There should ...

Rear Door Sash Outer Trim Replacement
4-door NOTE: Take care not to scratch the door. 1. Remove the door outer molding (see page 20-54). 2. Pull up the door sash outer trim (A) to release the trim from the clips, and release the t ...