Engine Mount Control System

Circuit Diagram

See also:

Bearing Removal
Special Tools Required •Attachment, 78x80 mm 07NAD-PX40100 -Driver Handle, 15 x 135L 07749-0010000 -Bearing Driver Attachment, 42 x 47 07746-0010300 1. Remove the idler gear shaft (see page 1 ...

CKP Sensor Replacement
1. Raise the vehicle on a lift. NOTE: Make sure the vehicle is level, because engine oil will drip out when you remove the sensor. 2. Remove the CKP sensor cover (A). 3. Disconnect the CKP s ...

Change Lever Clearance Inspection
1. Measure the clearance between the change lever (A) and the select lever (B) with a feeler gauge (C). If the clearance exceeds the service limit, go to step 2. Standard: 0.05-”0.25 mm (0.002 ...