Ignition System

...

Ignition Timing Inspection

1. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (see step 2 on page 11-3). 2. Turn the ignition switch to ON (II). 3. Make sure the HDS communicates with the vehic ...

See also:

Driveshaft Disassembly
Special'Tools Required •Threaded Adapter, 26 x 1.5 mm 07XAC-001030A -Slide Hammer 5/8M-18 UNF, commercially available -Bearing Puller, commercially available -Boot Band Pliers, commercially ...

Oil Filter Feed Pipe Replacement
1. Remove the oil filter base (see page 8-13). 2. Remove the oil filter feed pipe. 3. Install the two 20 x 1.5 mm nuts (A) onto the new oil filter feed pipe. Hold one nut with a wrench, then us ...

Component Location Index
...