Immobilizer System

...

System Description

The vehicle is equipped with a Type Vll (GEN 5) immobilizer system that will disable the vehicle unless a programmed ignition key is used. This system consists of a transponder combined with a k ...

See also:

CMP Pulse Plate B Replacement
1. Remove the cylinder head cover (see page 6-73). 2. Remove camshaft position (CMP) sensor B (see page 11-198). 3. Hold the camshaft with an open-end wrench, then loosen the bolt. 4. Remov ...

Brake Pedal and Brake Pedal Position Switch Adjustment
Pedal Height 1. Turn t h e brake p e d a l p o s i t i o n switch 45В° counterclockwise, and pull it back until it is no longer touching the brake pedal. 2. Remove the footrest (see step 4 on ...

Cylinder Head Inspection for Warpage
1. Remove the cylinder head (see page 6-76). 2. Inspect the camshaft (see page 6-84). 3. Check the cylinder head for warpage. Measure along the edges, and three ways across the center. - If ...