Reminder Systems

Circuit Diagram

See also:

Electrical Compass Unit Input Test
1. Remove the rear shelf (see page 20-128). 2. Loosen the bolts (A), then pull out the electrical compass unit bracket (B). 3. Disconnect the 6P connector (C) and remove the mounting bolt ( D ) ...

Changing a Flat Tire
If you have a flat tire while driving, pull over safely. Drive slowly along the shoulder until you get to an area far away from traffic lanes. The vehicle can easily roll off the jack, se ...

Mainshaft Thrust Clearance Adjustment
Special Tools Required - Mainshaft Holder 07GAJ-PG20110 - Mainshaft Base 07GAJ-PG20130 1. Remove the 72 mm shim (A) and oil guide plate M from the transmission housing (B). 2. Thoroughly clea ...