Gauges

...

Self-diagnostic Function

NOTE: Before testing, troubleshoot the multiplex integrated control unit first, using B-CAN System Diagnosis Test Mode A (see page 22-134). The gauge control module has a self-diagnostic functio ...

See also:

Damper/Spring Removal and Installation
Removal 1. Raise and support the vehicle (see page 1-13). 2. Remove the rear wheel. 3. Fold down the rear seat-back, then remove the lid (A). NOTE: For 4-door, lift up the tab (B) inside und ...

Trunk Lid Release Actuator Test
With Keyless Entry 1. Open the trunk lid. 2. Disconnect 3P connector f r om the trunk lid latch switch/trunk release actuator. 3. Check actuator operation by connecting power to terminal No. ...

Troubleshooting
Special Tools Required Vacuum Pump/Gauge, 0-”30 inHg Snap-on YA4000A or equivalent commercially available NOTE: - Check the vacuum hoses and the lines for damage and proper connections befor ...