Interior Lights

Circuit Diagram

See also:

Hood Seal and Hood Molding Replacement
NOTE: Take care not to scratch the hood. 1. Detach the clips (A) with a clip remover, then remove the hood seal (B). On Canada models: Detach the clips (C), then remove the hood molding (D). 2-d ...

 Steering Wheel Installation
SRS components are located in this area. Review the SRS component locations: 4-door {see page 24-21), 2-door (see page 24-23) and the precautions and procedures (see page 24-25) before doing repair ...

Immobilizer System
The immobilizer system prevents a key that has not been pre-registered from starting the engine. Each key contains electronic transmitters that use electronic signals to verify the key. Pay att ...