HFL Menus

The power mode must be in ACCESSORY or ON to use HFL. • Phone Settings screen 1. Press the SETTINGS button. 2. Rotate to select Phone Settings, then press . To use HFL, you must first pa ...

Compass Calibration

If the compass indicates the wrong direction, or the CAL indicator blinks, you need to manually calibrate the system. Compass operation can be affected under the following conditions: • Driv ...

See also:

A/T Clutch Pressure Control Solenoid Valve B and C Test
1. Connect the HDS to the DLC (A) located under the driver's side of the dashboard. 2. Turn the ignition switch to ON (II). Make sure the HDS communicates with the PCM. If it does not, go to the ...

Drive Plate Removal and Installation
1. Remove the transmission assembly (see page 14-194). 2. Remove the drive plate (A) and the washer (B) from the engine. 3. Install the drive plate and the washer on the engine, and tighten t ...

Compass Zone Selection
In most areas, there is a variation between magnetic north and true north. Zone selection is required so the compass can compensate for this variation. To check and select the zone, do this: ...