Honda Accord: Clutch Pedal Position Switch
Test - Cruise Control - Engine Electrical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Clutch Pedal Position Switch Test

M/T model

1. Disconnect the clutch pedal position switch 3P connector (A).

2. Remove the clutch pedal position switch (B).


2. Remove the clutch pedal position switch (B).

3. Check for continuity between the terminals according to the table.

- If the continuity is not as specified, replace the clutch pedal position switch (see page 4-46).

- If OK, install the clutch pedal position switch and adjust the pedal height (see page 12-7).


     Cruise Control Combination Switch Test/Replacement
    SRS components are located in this area. Review the SRS component locations:  2-door fsee page 24-23) 4-door (see page 24-21) Precautions and procedures (see page 24-25), in the SRS before d ...

    Clutch Pedal Position Switch Replacement
    M/T model 1 Disconnect the clutch pedal position switch connector (A). 2. Loosen the locknut (B), then remove the clutch pedal position switch (C). 3. Install the clutch pedal position switch ...

    See also:

    Rear Door Sash Inner Trim Replacement
    4-door NOTE: Take care not to scratch the door. 1. Remove the door panel (see page 20-38). 2. Lower the glass fully. 3. Remove the door sash inner trim (A). -1. Pull back the outside edge ...

    Transmission Range Switch Test
    1. Raise the vehicle on a lift, or apply the parking brake, block the rear wheels, and raise the front of the . vehicle. Make sure it is securely supported. 2. Remove the left front wheel. 3. ...

    Countershaft Disassembly
    NOTE: Refer to the Exploded View in the Countershaft Reassembly, as needed, when removing components pressed onto the countershaft (see page 13-46). 1. Securely clamp the countershaft assembly In ...