Honda Accord: Clutch Pedal Position Switch
Replacement - Cruise Control - Engine Electrical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Clutch Pedal Position Switch Replacement

M/T model

1 Disconnect the clutch pedal position switch connector (A).

2. Loosen the locknut (B), then remove the clutch pedal


2. Loosen the locknut (B), then remove the clutch pedal position switch (C).

3. Install the clutch pedal position switch, and adjust the pedal height (see page 12-7).

    Clutch Pedal Position Switch Test
    M/T model 1. Disconnect the clutch pedal position switch 3P connector (A). 2. Remove the clutch pedal position switch (B). 3. Check for continuity between the terminals according to the table ...

    Engine Mount Control System
    ...

    See also:

    Accessory Power Socket Trim Removal/Installation
    Special Tools Required KTC Trim Tool Set SOJATP2014* *Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE: - Take care not to scratch the console. - Use the approp ...

    Audio Unit Removal/Installation
    With Navigation SRS components are located in this area. Review the SRS component locations (see page 24-23), and the precautions and procedures (see page 24-25) before doing repairs or service. ...

    Wheel Speed Sensor Replacement
    Front 1. Turn the ignition switch to LOCK (0). 2. Release the clamp (A), then disconnect the wheel speed sensor connector (B). 3. Remove the bolts and the wheel speed sensor (C). 4. Install ...