Honda Accord: Clutch Master Cylinder Replacement
NOTE: - Use fender covers to avoid damaging painted surfaces.
- Do not spill brake fluid on the vehicle; it may damage the paint or plastic. If brake fluid does contact the paint or plastic, wash it off immediately with water.
1. Remove and discard the brake fluid from the clutch master cylinder reservoir with a syringe or other suitable device.
2. Pry out the lock pin (A), and pull the clevis pin (B) out of the clevis. Remove the master cylinder mounting nuts (C).
3. Remove the reservoir mounting bolt (A) and the retaining clip (B), then disconnect the clutch line (C) from the clutch master cylinder (D), and remove the O-ring (E). Plug or wrap the end of the clutch line with a clean shop towel to prevent brake fluid from coming out.
4. Remove the master cylinder (A) and the clutch master cylinder seal (B).
5. Install a new master cylinder seal (A), then install the master cylinder (B).
6. Install a new O-ring (A) on the clutch line (B), then install the clutch line in the clutch master cylinder (C) with a new retaining clip (D). Install the master cylinder reservoir mounting bolt (E).
NOTE: - Apply silicone grease (P/N 08C30- B0234M) to the O-ring and the end of the clutch line.
- Make sure not to get any silicone grease on the terminal part of the connectors and switches, especially if you have silicone grease on your hands or gloves.
7. To prevent the retaining clip (A) from coming off, pry apart the tip of the ciip (B) with a screwdriver.
8. Make sure the hose clamps (A) are positioned on the master cylinder (B) and reservoir (C) as shown.
9. Install the master cylinder mounting nuts (A).
10. Apply multipurpose grease to the clevis pin (B) and the mating surfaces (C) of the clevis and the pedal.
Slide the clevis pin into the clevis, then install the lock pin (D).
11. Bleed the clutch hydraulic system (see page 12-6).
12. Adjust the clutch pedal, the clutch pedal position switch, and the clutch interlock switch (see page 12-7).
13. Check the clutch operation, and check for leaks.
14. Test-drive the vehicle.
Clutch Pedal Assembly Replacement
1. Disconnect the clutch pedal position switch connector (A) and the clutch interlock switch connector (B). 2. Pry out the lock pin (C), and pull the clevis pin (D) out of the clevis. 3. Remov ...Slave Cylinder Replacement
NOTE: - Use fender covers to avoid damaging painted surfaces. - Do not spilt brake fluid on the vehicle; it may damage the paint or plastic. If brake fluid does contact the paint or plastic, wa ...See also:
Front Grille Cover Replacement
2-door
NOTE:
- Take care not to scratch the front grille or the body.
- When prying with a flat-tip screwdriver, wrap it with
protective tape to prevent damage.
1. Remove the front grille cov ...
USB Flash Memory Device Error Messages (Models with navigation system)
If you see an error message in the
center display while playing a USB
flash memory device, find the
solution in the chart to the right. If
you cannot clear the error message,
take your vehic ...
Cylinder Head
Component Location Index (cont'd)
Engine Compression Inspection
NOTE: After this inspection, you must reset the engine
control module (ECM)/powertrain control module
(PCM), otherwise the ECM ...