Honda Accord: Clutch Interlock Switch T e s t
M/T model
1. Disconnect the clutch interlock switch connector (A).

2. Remove the clutch interlock switch (B).
3. Check for continuity between the terminals according to the table.
- If the continuity is not as specified, replace the clutch interlock switch (see page 4-10).
- If OK, install the clutch interlock switch and adjust the pedal height (see page 12-7).

Starter System Circuit
Troubleshooting
Alternator, Regulator, Battery and Starter OTC3131 *
- Available through the Honda Tool and Equipment
Program 888-424-6857
NOTE:
- Air temperature must be within 59-”100 В°F (15-” ...
Clutch Interlock Switch
Replacement
M/T model
1, Disconnect the clutch interlock switch connector (A).
2. Loosen the locknut (B), then remove the clutch
interlock switch (C).
3. Install the clutch interlock switch, and adjust th ...
See also:
Air Mix Control Motor Replacement
1. Remove the driver's dashboard undercover (see page
20-170).
2. Disconnect the 7P connector (A) from the air mix
control motor (B). Remove the self-tapping screws
and the air mix control motor ...
Oil Seal Replacement
Special Tools Required
•Driver Handle, 15 x 135L 07749-0010000
•Oil Seal Driver Attachment 07947-SD90101
-Oil Seal Driver Attachment 07JAD-PH80101
1. Remove the oil seal from the transmi ...
CMP Pulse Plate A Replacement
1. Remove the cylinder head cover (see page 6-73).
2. Remove camshaft position (CMP) sensor A (see page
11-274).
3. Hold the camshaft with an open-end wrench, then
loosen the bolt.
4. Remov ...