Honda Accord: Clutch Interlock Switch
Replacement - Starting System - Engine Electrical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Clutch Interlock Switch Replacement

M/T model

1, Disconnect the clutch interlock switch connector (A).

2. Loosen the locknut (B), then remove the clutch


2. Loosen the locknut (B), then remove the clutch interlock switch (C).

3. Install the clutch interlock switch, and adjust the pedal height (see page 12-7).

    Clutch Interlock Switch T e s t
    M/T model 1. Disconnect the clutch interlock switch connector (A). 2. Remove the clutch interlock switch (B). 3. Check for continuity between the terminals according to the table. - If the ...

    Starter Performance Test
    1. Remove the starter (see page 4-11). 2. Firmly clamp the starter in a vise. 3. Make a connection for this test using the thickest (gauge) wire possible (preferably the same gauge as used on ...

    See also:

    Protecting Infants
    Child Seat Type An infant must be properly restrained in a rear-facing, reclining child seat until the child reaches the seat maker’s weight or height limit for the seat, and the child is ...

    Driver's Outer Dashboard Trim Removal/Installation
    Special Tools Required KTC Trim Tool Set SOJATP2014* *Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE: - Take care not to scratch the dashboard or the related pa ...

    Installing a Child Seat with a Tether
    A child seat with a tether can be installed in any seating position in the back seat, using one of the anchorage points shown above. Since a tether can provide additional security to the la ...