Honda Accord: Clutch Hose Replacement - Clutch - Transaxle - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Clutch Hose Replacement

NOTE: - Replace the clutch hose if it is twisted, cracked, or leaks.

- Use fender covers to avoid damaging painted surfaces.

- Do not spill brake fluid on the vehicle; it may damage the paint or plastic. If brake fluid does contact the paint or plastic, wash it off immediately with water.

1. Do the battery removal procedure (see page 22-92).

2. Remove the battery base bolts (A), loosen the two bolts (B), remove the cable clamp (C), and the harness bracket bolt (D), then remove the battery base (E).

3. Disconnect the clutch hose (A) from the clutch lines (B).


3. Disconnect the clutch hose (A) from the clutch lines (B).

4. Remove and discard the clutch hose clips (A) from the


4. Remove and discard the clutch hose clips (A) from the clutch hose (B).

5. Remove the clutch hose from clutch hose brackets.


5. Remove the clutch hose from clutch hose brackets.

6. Install the clutch hose (A) into the clutch hose brackets with new clutch hose clips (B).

7. Connect the clutch lines (A) to the clutch hose (B).


7. Connect the clutch lines (A) to the clutch hose (B).

8. Bleed the clutch hydraulic system (see page 12-6).


8. Bleed the clutch hydraulic system (see page 12-6).

9. Do the following checks: - Check the clutch hose and line joint for leaks, and tighten if necessary.

- Check the clutch hose for interference and twisting.

10. Install the battery base (A) and the cable clamp (B).

11. Do the battery installation procedure (see page 22-92).


11. Do the battery installation procedure (see page 22-92).

12. Test-drive the vehicle.

    Slave Cylinder Replacement
    NOTE: - Use fender covers to avoid damaging painted surfaces. - Do not spilt brake fluid on the vehicle; it may damage the paint or plastic. If brake fluid does contact the paint or plastic, wa ...

    Clutch Replacement
    Special Tools Required  - Clutch Alignment Disc 07JAF-PM7011A  - Ring Gear Holder 07LAB-PV00100 or 07924-PD20003  - Clutch Alignment Tool Set 07PAF-0020000  - Clutch Alignment ...

    See also:

    DOT Tire Quality Grading (U.S. Vehicles)
    The tires on your vehicle meet all U.S. Federal Safety Requirements. All tires are also graded for treadwear, traction, and temperature performance according to Department of Transportation ...

    General Troubleshooting Information
    General Operation Refer to the navigation system manual for the navigation system operating procedures. Anti-theft Feature The navigation system and audio unit have a coded theft protection circu ...

    Brightness Control
    When the parking lights are turned on and the ignition switch is in ON (w*1, you can use the brightness control knob to adjust instrument panel brightness. Brighten: Turn the knob to the righ ...