Component Location Index

...

Troubleshooting

Special Tools Required Vacuum Pump/Gauge, 0-”30 inHg Snap-on YA4000A or equivalent commercially available NOTE: - Check the vacuum hoses and the lines for damage and proper connections befor ...

See also:

Ball Joint Removal
Special Tools Required - Ball Joint Thread Protector, 14 mm 07AAE-SJAA100 - Ball Joint Thread Protector, 12 mm 07AAF-SDAA100 - Ball Joint Thread Protector, 10 mm 07AAF-SECA120 - Ball Joint Remover ...

Drive Belt Auto-tensioner Removal/Installation
1. Remove the drive belt (see page 4-30). 2. Remove the power steering (P/S) fluid reservoir from the holder. 3. Remove the P/S pump (A) without disconnecting the P/S hoses, then remove the P/ ...

Cf Hinder Bore Honing
Only a scored or scratched cylinder bore must be honed. 1. Measure the cylinder bores (see page 7-17). If the engine block is to be reused, hone the cylinders, and remeasure the bores. 2. Re ...