System Description

Overview The electrical compass shows the azimuth information in 8-directions (N, NE, E, SE, S, SW, W, NW) to the audio-HVAC display unit via the audio unit. Starting Operation When the igniti ...

Electrical Compass Zone Selection and Calibration

NOTE: • You should do this procedure any time the electrical compass unit is replaced. • You should do this procedure in an open area away from buildings, power lines, and other vehicl ...

See also:

Wheel Bolt Replacement
Special Tools Required B a i l Joint Remover, 28 mm 07MAC-SL0A202 - Do not use a hammer or impact tools (pneumatic or electric) to remove and install the wheel bolts. - Be careful not to damag ...

Evaporator Temperature Sensor Test
NOTE: Before testing the sensor, check for HVAC DTCs (see page 2 1 - 9). 1. Remove the evaporator temperature sensor (see page 21-67). 2. Dip the sensor in ice water, and measure the resistan ...

Courtesy Light Replacement
1 Carefully pry off the lens (A) with a small screwdriver. Courtesy Light: 2 CP 2. Remove the bulb (B) from the socket. 3. Install the light in the reverse order of removal. ...