Changing the Wiper Blade Rubber

1. Lift the driver side wiper arm first, then the passenger side. 2. Press and hold the tab, then slide the blade from the wiper arm. NOTICE Avoid dropping the wiper arm; it may damage the ...

Checking Tires

To safely operate your vehicle, your tires must be of the proper type and size, in good condition with adequate tread, and properly inflated. • Inflation guidelines Properly inflated tires pro ...

See also:

Reverse Idler Gear Removal and Installation
Removal 1. Remove the bolt (A) securing the reverse idler gear shaft holder (B). 2. Install a 5 x 0.8 mm bolt (C) in the reverse idler gear shaft (D), and pull it to remove the reverse idler gea ...

Shift Lock Stop/Shift Lock Stop Cushion Replacement
Type A Shift Lever 1. Remove the shift lock solenoid (see page 14-254). 2. Remove the shift lock stop (A) and the stop cushion (B) as a set. 3. Apply silicone grease to the pin (C) of the shif ...

PSP Switch Signal Circuit Troubleshooting
1. Start the engine, and let it idle. 2. Align the steering wheel straight ahead. 3. Check the PSP SWITCH in the DATA LIST with the HDS. Does it indicate ON? YES-Go to step 4. NO-Go to s ...