Honda Accord: Charging System
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Engine Electrical / Charging System
- Component Location Index
- Symptom Troubleshooting Index
- Circuit Diagram
- Charging System Indicator Circuit Troubleshooting
- Alternator and Regulator Circuit Troubleshooting
- Alternator Control Circuit Troubleshooting
- Drive Belt Inspection
- Drive Belt Removal/Installation
- Drive Belt Auto-tensioner Inspection
- Drive Belt Auto-tensioner Removal/Installation
- Tensioner Pulley Replacement
- Alternator Removal and Installation
- Alternator Overhaul
Spark Plug Inspection
1. Remove the ignition coils (see page 4-20).
2. Remove the spark plugs, then inspect the electrodes
and the ceramic insulator.
- Burned or worn electrodes may be caused by these
conditions:
...
See also:
Intermediate Shaft Installation
1. Clean the areas where the Intermediate shaft contacts
the differential thoroughly with solvent, and dry then
with compressed air.
NOTE: Do not wash the rubber parts with solvent.
2. Install ...
Ball Joint Boot Inspection / Replacemen
Special Tools Required
- Clip Guide, 45 mm 070AG-SJA0300
-Clip Guide, 41 mm 07974-SA50700
1. Check the ball joint boot for weakness, damage,
cracks, and grease leaks.
NOTE:
- If the ball joint ...
Front Brake Caliper Overhaul
Frequent inhalation of brake pad dust, regardless of material composition,
could be hazardous to your health.
- Avoid breathing dust particles.
- Never use an air hose or brush to clean brake ...