Honda Accord: Changing the Folders - Playing Discs (Models with navigation system) - Features - Honda Accord 2008-2012 Owner's ManualHonda Accord: Changing the Folders

While playing an MP3/WMA disc, you can select a folder within the disc by pressing either side of the category bar. Each time you press either side of the bar, the folder title and its first file’s information appear in the center display in recorded order.

Changing and Selecting the Folders/ Files

Using the interface selector, you can

Using the interface selector, you can see the list of all the files and folders within a disc. While playing a MP3/ WMA disc, press the AUDIO button.

The currently playing folder and file information comes on the screen.

Push ENTER on the selector to

Push ENTER on the selector to show the folder list. Turn the selector knob, highlight the folder you want to see the information within, and press ENTER.

You can see the list of all the files in

You can see the list of all the files in the selected folder. Turn the selector knob, then press ENTER to set your selection.

If the root folder has some additional folders in the lower layer, they will be listed on the screen.

    Playing an MP3/WMA Disc
    The changer plays MP3/WMA files in recorded order. Each disc can hold up to 400 playable files within 8 folder layers. When playing MP3 discs, a disc can support a maximum number of 100 fold ...

    Folder Scan
    This feature, when activated, samples the first file in each folder for 10 seconds. To scan a folder, press the SCAN side of the SCAN/ A. SEL bar repeatedly. You will see SCAN next to FOLDER ...

    See also:

    Selector Centre! Sheft Bearing Replacement
    Special Tools Required •Driver Handle, 15 x 135L 07749-0010000 -Attachment, 22 x 24 mm 07746-001A800 1. Remove the oil seal from the end cover, then remove the bearing. 2. Install a new be ...

    Piston, Pin, and Confyssfeg EQC Replacement
    Disassembly 1. Remove the piston from the engine block (see page 7-14). 2. Apply new engine oil to the piston pin snap rings (A), and turn them in the ring grooves until the end gaps are lined ...

    Back-up Light Switch Test
    1. Disconnect the back-up light switch 2P connector (A). 2. Check for continuity between back-up light switch 2P connector terminals No. 1 and No. 2. There should be continuity only when the shif ...