Honda Accord: Change Lever Clearance Inspection - Manual Transmission - Transaxle - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Change Lever Clearance Inspection

1. Measure the clearance between the change lever (A) and the select lever (B) with a feeler gauge (C). If the clearance exceeds the service limit, go to step 2.

Standard: 0.05-”0.25 mm (0.002-”0.010 in)

Service Limit: 0.50 mm (0.020 in)

2. Measure the groove width of the change lever.


2. Measure the groove width of the change lever.

- If the groove width is not within the standard, replace the change lever.

- If the groove width is within the standard, replace the select lever.

Standard: 15.00-15.10 mm (0.591-0.594 in)

Change Lever Assembly Disassembly/Reassembly


    Reverse Shift Fork Clearance Inspection
    1. Measure the clearance between the reverse Idler gear (A) and the reverse shift fork (B) with a feeler gauge (C). If the clearance exceeds the service limit, go to step 2. Standard; 0.20-0.59 mm ...

    Change Lever Assembly Disassembly/Reassembly
    NOTE: Prior to reassembling, clean all the parts in solvent, dry them, and apply grease to contact surfaces as shown. Do not wash the rubber parts with solvent. ...

    See also:

    Rear Door Latch Replacement
    4-door NOTE: Put on gloves to protect your hands. 1. Remove the door panel and the inner handle (see page 20-38). 2. Remove the plastic cover as needed (see step 3 on page 20-42). 3. Detac ...

     Cruise Control Combination Switch Test/Replacement
    SRS components are located in this area. Review the SRS component locations:  2-door fsee page 24-23) 4-door (see page 24-21) Precautions and procedures (see page 24-25), in the SRS before d ...

    Rear Defogger/Heated Door Mirror*Button
    Press the rear defogger and heated door mirror button to defog the rear window and mirrors when the ignition switch is in ON . The rear defogger and heated door mirrors automatically switc ...