Honda Accord: Center Pocket Removal/Installation - Dashboard - Body - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Center Pocket Removal/Installation

Without Navigation System

NOTE; - Take care not to scratch the dashboard or the related parts.

- A/T is shown; M/T is similar.

1. Remove the center console panel (see page 20-157).

2. A/T: Move the shift lever to 1st.

M/T: Move the shift lever to R.

3. Apply protective tapes (A) to the entire pocket lid face and the front area of the A/T gear position indicator panel (B) (A/T).

4. Open the lid, and remove the bolts securing the center


4. Open the lid, and remove the bolts securing the center pocket (A).

5. Pull out the center pocket (A), then remove it. Take


5. Pull out the center pocket (A), then remove it. Take care not to scratch the shift lever knob and the A/T gear position indicator panel (B) (A/T).


With Navigation System


With Navigation System

N O T E : - Take care not to scratch the dashboard or the related parts.

- A/T is shown; M/T is similar.

1. Remove the center console panel (see page 20-157).

2. A/T: Move the shift lever to 1st.

M/T: Move the shift lever to R.

3. Open the lid, and remove the bolts securing the center pocket (A).

4. Pull out the center pocket (A), then remove it. Take


4. Pull out the center pocket (A), then remove it. Take care not to scratch the shift lever knob and the A/T gear position indicator panel (B) (A/T ).

5. Install the center pocket in the reverse order of


5. Install the center pocket in the reverse order of removal.

    Driver's Inner Dashboard Trim Removal/Installation
    Special Tools Required KTC Trim Tool Set SOJATP2014* *Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE: - Take care not to scratch the dashboard or the related pa ...

    Dashboard Center Lower Cover Removal/Installation
    Special Tools Required KTC Trim Tool Set SOJATP2014* *Available through the Honda Tool and Equipment Program; call 888-424-6857 SRS components are located in this area. Review the SRS component ...

    See also:

    Special Tools
    ...

    Backlash Inspection
    1. Place the differential assembly on V-blocks (A), and install the intermediate shaft (B) and the left driveshaft (C). 2. Measure the backlash of both pinion gears (D) with a dial indicator (E) ...

    Function Test
    NOTE: The right power mirror is controlled by the front passenger's power w i n d o w s w i t c h . W h e n t h e power mirror s w i t c h is o p e r a t e d , t h e d o o r m u l t i p l e x c o n ...