Honda Accord: Carrier Bearing Replacement
Special Tools Required
Attachment, 40 x 50 mm 07LAD-PW50601
NOTE: -The bearing and the bearing outer race should be replaced as a set.
-Inspect and adjust the carrier bearing preload whenever bearing is replaced.
•Check the bearing for wear and rough rotation. If the bearing is OK, removal is not necessary.
1. Remove the carrier bearing (A) using a commercially available puller (B), a bearing separator (C), and a spacer (D).
2. Install new carrier bearings using the 40 x 50 mm attachment with the small end and a press. Press the carrier bearing on securely so there is no clearance between the carrier bearing and the differential carrier.
Backlash Inspection
1. Install both axles into the A/T differential, then place
the axles on V-blocks.
2. Check the backlash of the pinion gears (A) using a dial
indicator (B).
Standard: 0.05-0.15 mm (0.002-0.006 i ...
Differential Carrier and Final Driven
Gear Replacement
1. Remove the final driven gear (A) from the differential
carrier (B).
NOTE: Differential carrier bolts have left-hand
threads.
2. Install the final driven gear in the direction shown on
the ...
See also:
Transmission Number
Transmission Type
88E5: 5-speed Manual
M91 A: 5-speed Automatic
B90A: 5-speed Automatic
Serial Number
1000001-: M91A, B90A
8000001-: 88E5 ...
Operating the XM Radio
To listen to XM Radio, turn the
ignition switch to the ACCESSORY
(I) or ON (II) position, and press the
button. The
last channel you
listened to will show in the display.
Adjust the volume ...
Fuel Economy
Actual Mileage and EPA Fuel
Economy Estimates Comparison.
Fuel economy is not a fixed number.
It varies based on driving conditions,
driving habits, and vehicle condition.
Therefore, it is not ...