Honda Accord: Brake/Taillight and Rear Turn Signal Light/Rear SideMarker Light Bulbs
When replacing, use the following bulbs.
1. Remove the holding clips using a flat-tip screwdriver, then pull the lining back.
2. Turn the socket to the left and remove it.
3. Remove the old bulb and insert a new bulb.
Brake/taillight and rear side marker light bulbs are LED type. Have an authorized Honda dealer inspect and replace the light bulbs.
When removing the clip, insert a flat-tip screwdriver, then lift and remove the clip.
Insert the clip with the pin raised, and push until it is flat.
Parking Light Bulbs
When replacing, use the following bulbs.
Turn the steering wheel and pull the inner fender back in the same way as
when
replacing the front turn signal/side marker light bulbs.
1. Turn the s ...
Taillight and Back-Up Light Bulbs
When replacing, use the following bulbs.
1. Remove the holding clips using a flat-tip
screwdriver, then pull the lining back.
2. Turn the socket to the left and remove it.
3. Remove the ol ...
See also:
Engine Oil Life Display
To see the current engine oil life,
turn the ignition switch to the ON
(II) position, then press and release
the select/reset knob repeatedly
until the engine oil life indicator
appears.
...
Air Mix Control Motor Replacement
1. Remove the driver's dashboard undercover (see page
20-170).
2. Disconnect the 7P connector (A) from the air mix
control motor (B). Remove the self-tapping screws
and the air mix control motor ...