Honda Accord: Brake Pedal Replacement
1. Disconnect the brake pedal position switch connector ( A ) .
2. Remove the lock pin (B) and the clevis pin (C).
3. Remove the brake pedal support member (D).
4. Remove the brake pedal bracket mounting bolt (E) and nuts (F).
5. Remove the brake pedal with bracket (G).
6. Remove the brake pedal position switch (H) by turning it 45В° counterclockwise.
7. Install in the reverse order of removal.
8. Adjust the brake pedal and the brake pedal position switch (see page 19-8).
Rear Brake Caliper Overhaul
Frequent inhalation of brake pad dust, regardless of material composition,
could be hazardous to your health.
- Avoid breathing dust particles.
- Never use an air hose or brush to clean brake ...
Brake Hose and Line Inspection
1. Inspect t h e brake hoses for d a m a g e , deterioration, leaks,
interference, and twisting.
2. Check the brake lines for damage, rusting, and leaks. Also check for bent
brake lines.
3. ...
See also:
Fastening a Seat Belt
After adjusting a front seat to the proper position, and while sitting
upright and well
back in the seat:
2 Adjusting the Seats P. 148
1. Pull the seat belt out slowly.
2. Insert the latch ...
Vehicle Identification Number
Manufacturer, Make, and Type of Vehicle
1HG: Honda of America Mfg., Inc.
Honda passenger vehicle
Line, Body, and Engine Type
CS1: Accord Coupe/K24Z3
Body Type and Transmission Type
A: 2-door ...
Backlash Inspection
1. Install both axles into the A/T differential, then place
the axles on V-blocks.
2. Check the backlash of the pinion gears (A) using a dial
indicator (B).
Standard: 0.05-0.15 mm (0.002-0.006 i ...