Honda Accord: Brake Pedal Position Switch Test
1. Disconnect the 4P connector (A) from the brake pedal position switch (B).
2. Check for continuity between terminals No. 1 and No.
2.
• There should be continuity when the brake pedal is pressed.
• There should be no continuity when the brake pedal is released.
3. Check for continuity between terminals No. 3 and No.
4.
• There should be no continuity when the brake pedal is pressed.
• There should be continuity when the brake pedal is released.
4. If the test result are not as specified, adjust or replace the switch, or adjust the pedal height (see page 19-6).
If the results are still not as specified, replace the switch.
High Mount Brake Light Replacement
1. Open the trunk lid.
2. Disconnect the 2P connector (A) from the high mount
brake light.
High Mount Brake Light: 21 W
3. Turn the bulb socket (B) 45 В° counterclockwise to
remove the bulb ...
See also:
HVAC Control Power and Ground
Circuit Troubleshooting
1. Check the No. 16 (7.5 A) fuse in the driver's
under-dash fuse/ relay box.
Is the fuse OK?
YES-Go to step 2.
NO-Replace the fuse, and recheck. If the fuse blows
again, check for a short in ...
Cruise Control
Maintains a constant vehicle speed without having to keep your foot on the
accelerator. Use cruise control on freeways or open roads where you can travel
at a
constant speed with little accelera ...
Transmission Number
Transmission Type
88E5: 5-speed Manual
B90A: 5-speed Automatic
Serial Number
1000001-: B90A
8000001-: 88E5 ...