Wheel Speed Sensor Replacement

Front 1. Turn the ignition switch to LOCK (0). 2. Release the clamp (A), then disconnect the wheel speed sensor connector (B). 3. Remove the bolts and the wheel speed sensor (C). 4. Install ...

Doors

...

See also:

Driveshaft Installation
NOTE: Before starting Installation, make sure the mating surfaces of the joint and the splined section are clean. 1 Apply about 5 g (0.18 oz) of moly 60 paste (P/N 08734-0001) to the contact area ...

Precautions for Opening/Closing the Trunk
• Opening the trunk Open the trunk all the way.  - If it is not fully opened, the trunk lid may begin to close under its own weight. • Closing the trunk Keep the trunk lid closed while ...

Front Seat Slide Motor Replacement
SRS components are located in this area. Review the SRS component locations, 2-door (see page 24-23), 4-door (see page 24-21) and the precautions and procedures (see page 24-25) before doing repair ...