Honda Accord: Blower Unit Component Replacement
Note these items when overhauling the blower unit: • The recirculation control motor (A), the blower motor (B), and the dust and pollen filter (C) can be replaced without removing the blower unit.
• Before reassembly, make sure that the recirculation control linkage and door move smoothly without binding.
• After reassembly, make sure the recirculation control motor runs smoothly (see page 21-64).
Blower Unit Removal/Installation
1. Remove the glove box (see page 20-174). 2. Remove the passenger's undercover (see page 20-170). 3. Remove the right kick panel (see page 20-107). 4. Remove the dust and pollen filter asse ...Evaporator Core Replacement
1. Recover the refrigerant with a recovery/recycIing/charging station (see page 21-80). 2. Remove the bolt from the A/C line clamp (A). 3. Remove the bolt, then disconnect the A/C line (A) fro ...See also:
A/C Compressor Clutch Overhaul
Special Tools Required
• A/C Clutch Holder Robinair 10290 or Kent-Moore
J37872, commercially available
• A/C Clutch Holder Honda Tool and Equipment
ACT499A, commercially available
1. Re ...
Pump Replacement
1. Place a suitable container under the vehicle to catch
any spilled fluid.
2. Drain the power steering fluid from the reservoir (see
page 17-28).
3. Remove the drive belt (A) from the pump pu ...
USB Flash Memory Device Error Messages (Models with navigation system)
If you see an error message in the
center display while playing a USB
flash memory device, find the
solution in the chart to the right. If
you cannot clear the error message,
take your vehic ...