Honda Accord: Battery Terminal Disconnection and Reconnection
Disconnection
NOTE: Some systems store data in memory that is lost when the battery is disconnected. Do the following procedures before disconnecting the battery, 1. Make sure you have the anti-theft code(s) for the audio and/or the navigation system (if equipped).
2. If you are replacing the audio unit, write down the audio presets (AM and FM), and the XM audio presets (if equipped), because the audio unit does not retain the presets after the battery is disconnected.
3. Make sure the ignition switch is in LOCK (0).
4. Disconnect and isolate the negative cable from the battery.
NOTE: Always disconnect the negative cable from the battery first.
5. Disconnect the positive cable from the battery.
Reconnection
NOTE: Some systems store data in memory that is lost when the battery is disconnected. Do the following procedures to restore the system back to normal operation.
1. Clean the battery terminals.
2. Test the battery (see page 22-90).
3. Reconnect the positive cable (A) to the battery (B) first, then reconnect the negative cable (C) to the battery.
NOTE: Always connect the positive cable to the battery first.
4. Apply multipurpose grease to the terminals to prevent corrosion.
5. Enter the anti-theft code(s) for the audio system and/or the navigation system (if equipped).
6. Enter the audio presets (if applicable), and enter the XM audio presets (if equipped).
7. Set the clock (for vehicles without navigation).
Battery Test
A battery can explode if you do not follow the proper procedure, causing seiious injury to anyone nearby. Follow all procedures carefully and keep sparks and open flames away from the battery. R ...Battery Removal and Installation
NOTE: The battery terminal disconnection and reconnection procedure (see page 22-91) must be done before and after doing this procedure- Some systems store data in memory that is lost when the batt ...See also:
Circuit Diagram
DRIVER'S UNDER-DASH FUSE/RELAY
BOX CONNECTOR P (20P)
BRAKE PEDAL POSITION
SWITCH 4P CONNECTOR
GAUGE CONTROL MODULE 32P CONNECTOR
VSA OFF SWITCH
BP CONNECTOR
YAW RATE-LATERAL
ACCELE ...
PCV Valve Replacement
1. Disconnect the PCV hose.
2. Remove the PCV valve (A).
3. Install the parts in the reverse order of removal with a
new washer (B). ...
Refrigerant Recovery
• Air conditioning refrigerant or lubricant vapor can
irritate your eyes, nose, or throat.
• Be careful when connecting service
equipment.
•Do not breathe refrigerant or vapor. ...