Honda Accord: Battery Removal and Installation
NOTE: The battery terminal disconnection and reconnection procedure (see page 22-91) must be done before and after doing this procedure- Some systems store data in memory that is lost when the battery is disconnected.
Removal
1. Do the battery terminal disconnection procedure (see page 22-91).
2. Remove the two nuts (A) securing the battery setting plate, then remove the battery setting plate (B) and the battery (C).
Installation
1. Install the battery (A), then install the battery setting plate (B).
2. Tighten the two nuts (C) equally until the battery is stable.
NOTE: Do not deform the battery setting plate by tightening the nuts too much.
3. Do the battery terminal reconnection procedure (see page 22-91).
NOTE: Make sure the battery is installed correctly, and the positive terminal and the negative terminal are not reversed.
Battery Terminal Disconnection and
Reconnection
Disconnection
NOTE: Some systems store data in memory that is lost
when the battery is disconnected. Do the following
procedures before disconnecting the battery,
1. Make sure you have the anti-th ...
Relays
Power Relay Test
Special Tools Required
Relay Puller 07AAC-000A1A0
Use this chart to identify the type of relay, then do the
test listed for it.
*1:'08-09 models
*2: Carefully remove the relay ...
See also:
Wheel and Tire Specifications
Wheels
4-cylinder models:
17 x 7 1/2J
V6 models:
18 x 8J
Tires
4-cylinder models:
P225/50R17 93V
V6 models:
P235/45R18 94V ...
Instrument Visor Removal/Installation
Special Tools Required
KTC Trim Too! Set SOJATP2014*
*Available through the Honda Tool a n d Equipment
Program; call 888-424-6857
NOTE:
- Take care not to scratch the dashboard or the related
pa ...
Power Seat Adjustment Switch
Test/Replacement
1. Remove the driver's seat (see page 20-194).
2. Remove the power seat adjustment switch knobs (A) and the recline cover from
the driver's seat.
• 4-door (see page 20-234)
• 2-door ...