Passenger's Under-dash Fuse/Relay Box (MICU) Removal and Installation

NOTE: SRS components are located in this area. Review the SRS component locations 4-door (see page 24-21), 2-door (see page 24-23), and precautions, and procedures (see page 24-25) before doing rep ...

Battery Test

A battery can explode if you do not follow the proper procedure, causing seiious injury to anyone nearby. Follow all procedures carefully and keep sparks and open flames away from the battery. R ...

See also:

Oil Filter Feed Pipe Replacement
1. Remove the oil filter base (see page 8-13). 2. Remove the oil filter feed pipe. 3. Install the two 20 x 1.5 mm nuts (A) onto the new oil filter feed pipe. Hold one nut with a wrench, then us ...

Mainshaft Bearing and Oil Seal Replacement
Special Tools Required -Adjustable Bearing Puller, 2 5 - 4 0 mm 07736-A01000B -Driver Handle, 15 x 135L 07749-0010000 -Attachment, 62 x 68 mm 07746-0010500 -Attachment, 72 x 75 mm 07746-0010600 1 ...

Mode Control Motor Replacement
1. Remove the blower unit (see page 21-65). 2. Disconnect the 7P connector (A) from the mode control motor (B). Remove the self-tapping screws and the mode control motor from the heater unit. ...