Honda Accord: Backlash Inspection
1. Place the differential assembly on V-blocks (A), and install the intermediate shaft (B) and the left driveshaft (C).
2. Measure the backlash of both pinion gears (D) with a dial indicator (E). If the backlash is not within the standard, check the differential carrier condition, and replace it if necessary.
Standard (New): 0.05-”0.15 mm
(0.002-0.006 in)
Differential Carrier/Final Driven Gear Replacemen
1. Loosen the bolts in a crisscross pattern in several
steps, then remove the bolts and the final driven gear
(A) from the differential carrier (B).
2. Install the final driven gear with the cham ...
See also:
Front Bumper Removal/Installation
NOTE:
- Have an assistant help you when removing and
installing the front bumper.
- Take care not to scratch the front bumper
or the body.
- Put on gloves to protect your hands.
- When pr ...
Glove Box Striker Replacement
SRS components are located in this area. Review the
SRS component locations, 2-door {see page 24-23),
4-door (see page 24-21) and the precautions and
procedures (see page 24-25) before doing repair ...
Steering Column Removal and Installation
SRS components are located in this area. Review the
SRS component locations: 4-door (see page 24-21 )f
2-door (see page 24-23) and the precautions and
procedures (see page 24-25) before doing repai ...