Honda Accord: Backlash Inspection - A/T Differential - Transaxle - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Backlash Inspection

1. Install both axles into the A/T differential, then place the axles on V-blocks.

2. Check the backlash of the pinion gears (A) using a dial indicator (B).

Standard: 0.05-0.15 mm (0.002-0.006 in)

3. If the backlash is out of standard, replace the


3. If the backlash is out of standard, replace the differential carrier (see page 14-329).

    Component Location Index
    ...

    Carrier Bearing Replacement
    Special Tools Required Attachment, 40 x 50 mm 07LAD-PW50601 NOTE: -The bearing and the bearing outer race should be replaced as a set. -Inspect and adjust the carrier bearing preload wheneve ...

    See also:

    Clutch Hydraulic System Bleeding
    NOTE: - Do not reuse the drained fluid. Always use Honda DOT 3 Brake Fluid from an unopened container. Using a non-Honda brake fluid can cause corrosion and shorten the life of the system. - Ma ...

    Moonroof Switch Test/Replacement
    1. Remove the front Individual map lights (see page 22-258). 2. Disconnect the moonroof switch 12P connector (A) and map light 3P connector (B). 3. Remove the moonroof switch (C) from the map ...

    Front Seat Cushion Cover Replacement
    Special Tools Required KTC Trim Tool Set SOJATP2014* *Available through the Honda Tool and Equipment Program; call 888-424-6857 2-door SRS components are located in this area. Review the SRS c ...