Automatic Transmission and A/T Differential (cont'd)

Steering

See also:

Cf Hinder Bore Honing
Only a scored or scratched cylinder bore must be honed. 1. Measure the cylinder bores (see page 7-17). If the engine block is to be reused, hone the cylinders, and remeasure the bores. 2. Re ...

Intermediate Shaft Disassembly
Special Tools Required •Half Shaft Base 07NAF-SR30101 -Oil Seal Driver, 44.5 mm 07947-SB00100 1. Remove the heat shield (A). 3. Press the intermediate shaft (A) out of the intermediate s ...

Clutch Interlock Switch T e s t
M/T model 1. Disconnect the clutch interlock switch connector (A). 2. Remove the clutch interlock switch (B). 3. Check for continuity between the terminals according to the table. - If the ...