Honda Accord: Automatic Seat Belt Tensioners
For added protection, the front seat belts are equipped with automatic seat belt tensioners. When activated, the tensioners immediately tighten the belts to help hold the driver and a front passenger in position.
The tensioners can be activated during a collision in which the front airbags do not deploy. In this case, the airbags would not be needed, but the additional restraint could be helpful.
If the tensioner is activated, the SRS indicator comes on and the tensioner must be replaced.
Lap/Shoulder Belt
The lap/shoulder belt goes over
your shoulder, across your chest,
and across your hips.
To fasten the belt, insert the latch
plate into the buckle, then tug on the
belt to make sure the buckl ...
Seat Belt Maintenance
For safety, you should check the
condition of your seat belts regularly.
Pull each belt out fully, and look for
frays, cuts, burns, and wear. Check
that the latches work smoothly and
the belt ...
See also:
Driveshaft Installation
NOTE: Before starting Installation, make sure the mating
surfaces of the joint and the splined section are clean.
1 Apply about 5 g (0.18 oz) of moly 60 paste
(P/N 08734-0001) to the contact area ...
Power Mirror Actuator Replacement
Removal
1. Remove the mirror holder (see page 20-63).
2. Remove the power mirror (see page 20-62), and
disconnect the power mirror 8P connector from the
door wire harness.
3. Remove the gaske ...
Handling the Unexpected
This chapter explains how to handle unexpected troubles. ...