Power Mirror Actuator Replacement

Removal 1. Remove the mirror holder (see page 20-63). 2. Remove the power mirror (see page 20-62), and disconnect the power mirror 8P connector from the door wire harness. 3. Remove the gaske ...

Circuit Diagram

...

See also:

DTC Troubleshooting
DTC B10A2: Driver's MICU (EEPROM) Error NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see page 22-134). 1. Clear the D ...

Secondary Shaft 2nd Gear Axial Clearance Inspection
1. Install the thrust needle bearing (A), the needle bearing (B), 2nd gear (C), the thrust needle bearing (D), the 37 x 58 mm thrust washer (E), and the 2nd clutch (F) on the secondary shaft (G), t ...

VSA Modulator-Control Unit Removal and Installation
N O T E : - Do not spill brake fluid on the vehicle; it may damage the paint. If brake fluid gets on the paint, wash it off immediately with water. - Be careful not to damage or deform the brake ...