Honda Accord: Auto Door Locking - Door Locks - Instruments and Controls - Honda Accord 2008-2012 Owner's ManualHonda Accord: Auto Door Locking

The auto door locking feature has three possible settings:

The auto door locking is deactivated all the time.

The doors lock whenever you move the shift lever out of the Park (P) position (A/T vehicles).

The doors lock when the vehicle speed reaches 10 mph (15 km/h).

This is the default setting.

To turn off the Auto Door Lock modes:

1. Make sure the shift lever is in the

1. Make sure the shift lever is in the Park (P) position (A/T vehicles).

2. Turn the ignition switch to the ON (II) position, and open the driver’s door.

3. Push and hold the front of the master door lock switch on the driver’s door until you hear a click (after about 5 seconds).

4. Release the switch, and within 20 seconds, turn the ignition switch to the LOCK (0) position.

To program the Park Lock mode:

Locks both doors when the shift lever is moved out of the Park (P) position (A/T vehicles only).

1.Make sure the shift lever is in the

1.Make sure the shift lever is in the Park (P) position.

2. Turn the ignition switch to the ON (II) position, and make sure to close the driver’s door.

3. Push and hold the front of the master door lock switch on the driver’s door. You will hear a click.

Keep holding the switch until you hear another click (after about 5 seconds).

4. Release the switch, and within 20 seconds, turn the ignition switch to the LOCK (0) position.

To program the Drive Lock mode:

Locks both doors when the vehicle’s speed reaches about 10 mph (15 km/h).

1. Make sure the shift lever is in the

1. Make sure the shift lever is in the Park (P) position (A/T vehicles).

2. Turn the ignition switch to the ON (II) position, and make sure to close the driver’s door.

3. On A/T vehicles, push and hold the brake pedal, and move the shift lever out of the Park (P) position.

4. Push and hold the front of the master door lock switch on the driver’s door. You will hear a click.

Keep holding the switch until you hear another click (after about 5 seconds).

5. Release the switch, and within 20 seconds, turn the ignition switch to the ACCESSORY (I) position.

On A/T vehicles, move the shift lever to the Park (P) position.

6. Turn the ignition switch to the LOCK (0) position.

    Auto Door Locking/Unlocking
    Your vehicle has customizable settings for the doors to automatically lock and unlock. There are default settings for each of these features. You can turn off or change the settings for thes ...

    Auto Door Unlocking
    The auto door unlocking feature has five possible settings: The auto door unlocking is deactivated all the time. On A/T vehicles, the driver’s door unlocks when you move the shift lever to ...

    See also:

    Replacing a Front Turn Signal/Parking Light Bulb
    1.  Open the hood. To change the turn signal bulb on the passenger’s side, remove the engine coolant reserve tank by pulling it out of its stay. Driver’s side on V6 models Remove t ...

    Ignition Coil and Spark Plug Removal/Installation
    1. Remove the ignition coil cover (A). 2. Disconnect the ignition coil connectors (B), then remove the ignition coils (C). 3. Remove the spark plug and inspect them (see page 4-20). 4. Appl ...

    Replacing Tires andWheels
    Replace your tires with radial tires of the same size, load range, speed rating, and maximum cold tire pressure rating (as shown on the tire’s sidewall). Mixing radial and bias-ply tires on ...