Honda Accord: Audio System Theft Protection*
The audio system is disabled when it is disconnected from the power source, such as when the battery is disconnected or goes dead.
• Reactivating the audio system
1. Set the power mode to ON, and turn on the audio system.
- If you set the power mode to ACCESSORY, you will be requested to enter the
audio security code. See step 3.
2. Press and hold the power button again for more than two seconds.
- The audio system is reactivated when the system’s control unit recognizes that
the system is in your vehicle.
If the control unit fails to recognize, Enter PIN Code appears on the
audio/
information screen.
3. Enter the audio security code using the touch screen. If you enter an
incorrect
digit, continue to the last digit, then try again. If you do not enter code
correctly
after 10 tries, leave the system for one hour before trying again, or visit a
dealer
to have the system reset.
Find the audio system's security code and serial number label in your owner’s manual kit.
We recommend that you write down the serial number in this owner’s manual.
Do not store the label in your vehicle. If you lose the label, you must first retrieve the serial number, and then obtain the code.
You can find out about your serial number and security code from a dealer.
You can register the security code at Owner Link (owners.honda.com.), and find information on how to retrieve the serial number and obtain the code at radio-navicode.honda.com.
Auxiliary Input Jack
Use the jack to connect standard audio devices.
1. Open the AUX cover.
2. Connect a standard audio device to the
input jack using a 1/8 inch (3.5 mm) stereo
miniplug.
- The audio syst ...
Region Setting
The audio system’s region setting will be lost when the battery is
disconnected or
goes dead.
If the Region Select screen appears, you need to set the region for
the audio
system. Follow th ...
See also:
A/C Refrigerant Oil Replacement
Recommended PAG oil: DENSO ND-OIL 8
P/N 38897-PR7-A01AH: 120 m l (4 fl-oz)
It is important to have the correct amount of refrigerant
oil in the A/C system to ensure proper lubrication of the
A/C c ...
Disc Scan
When you press the SCAN side of
the SCAN/A. SEL bar repeatedly
until you see D-SCAN in the center
display, or push the interface
selector to the right, the first track of
the current disc pl ...
Rewriting the ODO Data and
Transferring the Maintenance
Minder Data to a New Gauge Control
Module
NOTE:
• Obtain a new gauge control module before starting
the rewriting process. Only new gauges can be
rewritten.
• Rewriting is not possible on a gauge control module
that will not ...