Honda Accord: Audio System Basic Operation
To use the audio system function, the ignition switch must be in ACCESSORY
or
ON 
Use the selector knob or MENU button to access some audio functions.
Press 
to switch between the
normal and
extended display for some functions.
Selector knob: Rotate left or right to scroll through the available choices. Press to set your selection.
MENU button: Press to select any mode.
The available mode includes Change Source, Station List, Save Preset, Radio Text, Music Search, and play modes. Play modes can be also selected from Scan, Random/ Repeat, and so on.
BACK button: Press to go back to the previous display.
button: Press to change the
audio/
information screen brightness.
Press 
once and make an adjustment.
uEach time you press 
, the mode
switches between the daytime mode,
nighttime mode and OFF mode.
These indications are used to show how to operate the selector knob.
Rotate 
to select.
Press 
to enter.
- Audio/Information Screen
- Adjusting the Sound
- Display Setup
- Playing AM/FM Radio
- Playing a CD
- Playing an iPod®
- Playing Internet Radio
- Playing a USB Flash Drive
- Playing Bluetooth® Audio
Audio Remote Controls
Allows you to operate the audio system while driving.
The CD mode appears only when a CD is loaded.
...
Audio/Information Screen
Displays the audio status and wallpaper. From this screen, you can go to
various
setup options.
• Switching the Display
Press the (display) button to
change the display.
• Audio
Shows ...
See also:
Disc Changer Error Messages (Models with navigation system)
The chart on the right explains the
error messages you may see in the
center display while playing a disc.
If you see an error message in the
center display while playing a disc,
press the ej ...
Climate Control Switch
Removal / Installation
With Navigation
1 Remove the audio unit (see page 23-114).
2. Remove the self-tapping screws and the climate
control switches (A). If necessary, replace the bulbs
(B).
3. Install the switches ...
Connector Index
Identification numbers have been assigned to in-line connectors, junction
connectors, and terminals. The number is preceded by the letter "C"
for connectors, " G " for ground te ...