Honda Accord: Audio Remote Switch Test
1. Remove the steering wheel (see page 17-6).
2. Remove the audio remote switch (see page 17-7).
3. Measure the resistance between the terminals No. 1 and No. 8 in each switch position according to the table.
4. If the resistance is not as specified, replace the audio remote switch.
Speaker Test/Replacement
Front Door Speaker
1. Remove the door panel.
• 4-door (see page 20-17)
• 2-door (see page 20-12)
2. Remove t h e bolt (A). Then lift the speaker straight up
to release t h e lower cli ...
AM/FM Antenna Amplifier
Replacement
1. Remove the C-pillar trim.
• 4-door (see page 20-110)
• 2-door (see page 20-110)
2. Disconnect the connectors (A) from the AM/FM
antenna amplifier (B).
4-Door
2-Door
3. Remove ...
See also:
Control Unit Input Test
NOTE: Before testing, troubleshoot the multiplex integrated control unit
first, using B-CAN System Diagnosis Test Mode
A (see page 22-134), and make sure the lighting system works properly.
Driver ...
Symptom Troubleshooting
Rapid brake pad wear, vehicle vibration
(after a long drive), or high, hard brake pedal
NOTE: Make sure that the caliper pins are installed
correctly. Upper caliper pin B and lower caliper pin A ar ...
Radio Theft Protection
Your vehicle’s audio system may
disable itself if it is disconnected
from electrical power for any reason.
To make it work again, you must
enter a specific five-digit code with
the preset b ...