Honda Accord: ATF Feed Pipe Replacement - Transmission End Cover - Transaxle - Honda Accord MK8 2008-2012 Service ManualHonda Accord: ATF Feed Pipe Replacement

1. Remove the snap rings (A), the ATF feed pipes (B), and the feed pipe flanges (C) from the end cover (D).

NOTE: Replace the end cover, if the 1st clutch ATF feed pipe (E) replacement is required.

2. Install new O-rings (F) over the ATF feed pipes.


2. Install new O-rings (F) over the ATF feed pipes.

3. Install the ATF feed pipes in the end cover by aligning the feed pipe tabs with the indentations in the end cover.

4. Install new O-rings (G) in the end cover, then install the feed pipe flanges over the ATF feed pipes.

5. Secure the ATF feed pipes and the feed pipe flanges with the snap rings.

    Selector Centre! Sheft Bearing Replacement
    Special Tools Required •Driver Handle, 15 x 135L 07749-0010000 -Attachment, 22 x 24 mm 07746-001A800 1. Remove the oil seal from the end cover, then remove the bearing. 2. Install a new be ...

    Transmission Housing
    ...

    See also:

    Circuit Diagram
    ...

    Component Location Index
    ...

    Cf Under Head Removal
    NOTE: - Use fender covers to avoid damaging painted surfaces. - To avoid damage, unplug the wiring connectors carefully while holding the connector portion. - Connect the Honda Diagnostic Sys ...