Honda Accord: Ambient Light Replacement - Interior Lights - Body Electrical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Ambient Light Replacement

With moonroof

NOTE: The ambient light is built into the moonroof switch.

1. Remove the front individual map lights (see page 22-258).

2. Disconnect the moonroof switch 12P connector (A) and the map light 3P connector (B).

3. Remove the moonroof switch (C) from the map light


3. Remove the moonroof switch (C) from the map light housing.

4. At the moonroof switch 12P connector, check the light by connecting battery power to terminal No. 3 and ground to terminal No. 1. The ambient light should come on. If the light does not come on, replace the moonroof switch assembly.

5. Install the parts in the reverse order of removal.

    Interior Light Switch Test/Replacement
    With moonroof NOTE: The Interior light switch is built into the moonroof switch, and it switches the front individual map light OFF and DOOR positions. 1. Remove the front individual map lights ...

    Courtesy Light Replacement
    1 Carefully pry off the lens (A) with a small screwdriver. Courtesy Light: 2 CP 2. Remove the bulb (B) from the socket. 3. Install the light in the reverse order of removal. ...

    See also:

    Component Location Index
    ...

    Wipers and Washers
    The windshield wipers and washers can be used when the ignition switch is in ON . • MIST The wipers run at high speed until you release the lever. • Wiper switch (OFF, INT, LO, HI) Chan ...

    Ball Joint Boot Inspection / Replacemen
    Special Tools Required - Clip Guide, 45 mm 070AG-SJA0300 -Clip Guide, 41 mm 07974-SA50700 1. Check the ball joint boot for weakness, damage, cracks, and grease leaks. NOTE: - If the ball joint ...