Honda Accord: Air Mix Control Motor Replacement - Heating/Air Conditioning - Heating, Ventilation, and Air Conditioning - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Air Mix Control Motor Replacement

1. Remove the driver's dashboard undercover (see page 20-170).

2. Disconnect the 7P connector (A) from the air mix control motor (B). Remove the self-tapping screws and the air mix control motor from the heater unit.

3. Install the motor in the reverse order of removal.


3. Install the motor in the reverse order of removal.

Make sure the pin on the motor is properly engaged with the linkage. After installation, make sure the motor runs smoothly.

    Air Mix Control Motor Test
    NOTE: Before testing the motor, check for HVAC DTCs (see page 21-9). 1. Disconnect the 7P connector from the air mix control motor. Incorrectly applying power and ground to the air mix contro ...

    Mode Control Motor Test
    '08-09 models with A/T and '10 model with A/T NOTE; Before testing the motor, check for HVAC DTCs (see page 21-9). 1. Disconnect the 7P connector from the mode control motor. Incorrectly app ...

    See also:

    Warranty Coverages
    • U.S. Owners Your new vehicle is covered by these warranties: New Vehicle Limited Warranty – covers your new vehicle, except for the emissions control systems and accessories, against defects ...

    Wheel Bolt Replacement
    Special Tools Required B a i l Joint Remover, 28 mm 07MAC-SL0A202 - Do not use a hammer or impact tools (pneumatic or electric) to remove and install the wheel bolts. - Be careful not to damag ...

    System Description
    TPMS Control Unit Inputs and Outputs for 20P Connector Wire side of female terminals System Structure Once the vehicle speed exceeds 28 mph (45 km/h), the TPMS control unit monitors all four ...