Honda Accord: Adjusting the Power Mirrors - Mirrors - Instruments and Controls - Honda Accord 2008-2012 Owner's ManualHonda Accord: Adjusting the Power Mirrors

1. Turn the ignition switch to the ON

1. Turn the ignition switch to the ON (II) position.

2. Move the selector switch to L (driver’s side) or R (passenger’s side).

3. Push the appropriate edge of the adjustment switch to move the mirror right, left, up, or down.

4. When you finish, move the selector switch to the center (off) position. This turns the adjustment switch off to keep your settings.

    Mirrors
    Keep the inside and outside mirrors clean and adjusted for best visibility. Be sure to adjust the mirrors before you start driving. The inside mirror has day and night positions. The night p ...

    Power Mirror Heaters
    All Canadian models U.S. EX, EX-L and all V6 models The outside mirrors are heated to remove fog and frost. With the ignition switch in the ON (II) position, turn on the heaters by pressi ...

    See also:

    Tensioner Pulley Replacement
    1. Remove the auto-tensioner (see page 4-31). 2. Clamp the auto-tensioner (A) by using two 8 mm bolts (B) and a vise (C) as shown. Do not clamp the auto-tensioner itself, then remove the tensione ...

    Sunglasses Holder
    To open the sunglasses holder, push then release the indent. It will unlatch and swing down. To close it, push it until it latches. Make sure the holder is closed while you are driving. S ...

    Inspection
    Out of Vehicle For front seat belt retractors with seat belt tensioners, review the SRS component locations, 2-door (see page 24-23), 4-door (see page 24-21) and the precautions and procedures (se ...