Honda Accord: Additional Information on Recommended Discs - Protecting Your Discs - Features - Honda Accord 2008-2012 Owner's ManualHonda Accord: Additional Information on Recommended Discs

The in-dash disc player/changer has a sophisticated and delicate mechanism. If you insert a damaged disc as indicated in this section, it may become stuck inside and damage the audio unit.

Examples of these discs are shown to the right:

1. Bubbled, wrinkled, labeled, and excessively thick discs

1. Bubbled, wrinkled, labeled, and excessively thick discs

2. Damaged discs

2. Damaged discs

3. Poor quality discs

3. Poor quality discs

4. Small, irregular shaped discs

4. Small, irregular shaped discs

5. Discs with scratches, dirty discs

5. Discs with scratches, dirty discs

CD-R or CD-RW may not play due to the recording conditions.

Scratches and fingerprints on the discs may cause the sound to skip.

Recommended discs are printed with the following logo.

Audio unit may not play the

Audio unit may not play the following formats.

This audio unit cannot play a Dualdisc

This audio unit cannot play a Dualdisc .

    Protecting Discs
    When a disc is not being played, store it in its case to protect it from dust and other contamination. To prevent warpage, keep discs out of direct sunlight and extreme heat. To clean a disc, ...

    FM/AM Radio Reception
    ...

    See also:

    Dashboard Center Lower Cover Removal/Installation
    Special Tools Required KTC Trim Tool Set SOJATP2014* *Available through the Honda Tool and Equipment Program; call 888-424-6857 SRS components are located in this area. Review the SRS component ...

    Fuel Pressure Test
    Special Tools Required - Fuel Pressure Gauge 07406-004000B - Fuel Pressure Gauge Attachment Set 07AAJ-S6MA150 1. Relieve the fuel pressure (see page 11-306). 2. Attach the fuel pressure gauge se ...

    CMP Sensor B Replacement
    1. Disconnect the connector (A) and hoses (B) from the EVAP canister purge valve (C), then remove the EVAP canister purge valve assembly. 2. Disconnect the CMP sensor B connector (A). 3. Remov ...