Honda Accord: Accessory Power Sockets

Your vehicle has two accessory power sockets; one is at the front of the center console and the other is in the console compartment.
To use an accessory power socket, the ignition switch must be in the ACCESSORY (I) or ON (II) position.

Each socket is intended to supply power for 12 volt DC accessories that are rated 120 watts or less (10 amps).
None of the sockets will power an automotive type cigarette lighter element.
Make sure to put the socket cover back in place to prevent any small foreign objects from getting into the socket.
Console Compartment
To open the console compartment,
pull up on the lever and lift the
armrest.
To close, lower the armrest, and
push it down until it latches. ...
Sun Visor
To use the sun visor, pull it down.
When using the sun visor for the
side window, remove the support rod
from the clip, and swing it out.
In this position, the sun visor can be
adjusted by m ...
See also:
Driving Safely with a Trailer
• Things You Need To Know Before Towing a Trailer
• Have the trailer properly serviced and keep it in good condition.
• Make sure that all the weights and load in the vehicle and trailer are ...
Remote Transmitter
LOCK - Press this button once to
lock both doors. Some exterior lights
will flash once. When you push
LOCK twice within 5 seconds, you
will hear a beep to verify that the
doors are locked ...
Rear Seat Belt Replacement
Rear Seat Beit
NOTE:
• Put on gloves to protect your hands.
• Take care not to tear or damage the seat
covers.
• Check the rear seat belts for damage (see page 24-18),
and re ...