Moonroof Switch Test/Replacement

1. Remove the front Individual map lights (see page 22-258). 2. Disconnect the moonroof switch 12P connector (A) and map light 3P connector (B). 3. Remove the moonroof switch (C) from the map ...

Component Location index

...

See also:

ODS Unit Initialization
NOTE: • After SRS unit or ODS unit is replaced, do this procedure to initialize the ODS unit. • ODS unit initialization will initialize both OPDS sensor and front passenger's weight se ...

Fuel Tank Unit Removal and Installation
Special Tools Required Fuel Sender Wrench 07AAA-S0XA100 Removal 1. Relieve the fuel pressure (see page 11-306). 2. Remove the fuel fill cap. 3. Remove the rear seat cushion (see page 20-241). ...

Lower Arm B Replacement
1 Raise and support the vehicle (see page 1-13). 2. Remove the rear wheel. 3. Remove the lower arm B mounting bolts, then remove lower arm B. NOTE: Use new mounting bolts during reassembly. ...