Honda Accord: Accessories - Accessories and Modifications - Driving - Honda Accord 2013-2026 Owner's ManualHonda Accord: Accessories

When installing accessories, check the following:

• Do not install accessories on the windshield. They can obstruct your view and delay your reaction to driving conditions.
• Do not install accessories on the side pillars or across the side windows.
Accessories installed in these areas may interfere with proper operation of the side curtain airbags.
• Be sure electronic accessories do not overload electrical circuits or interfere with proper operation of your vehicle.
• Before installing any electronic accessory, have the installer contact a dealer for assistance. If possible, have a dealer inspect the final installation.

WARNING

Improper accessories or modifications can affect your vehicle's handling, stability, and performance, and cause a crash in which you can be seriously hurt or killed.

Follow all instructions in this owner's manual regarding accessories and modifications.

Honda Genuine accessories are recommended to ensure proper operation on your vehicle.

    Accessories and Modifications
    ...

    Modifications
    Do not modify your vehicle or use non-Honda components that can affect its handling, stability, and reliability. Overall vehicle performance can be affected. Always make sure all equipment is p ...

    See also:

    Rear Door Outer Molding Replacement
    Special Tools Required KTC Trim Tool Set SOJATP2014* - Available through the Honda Tool and Equipment Program; call 888-424-6857 4-door N O T E : - If you remove the door outer molding, replace ...

    Engine Number
    Engine Type K24Z2: 2.4 L DOHC i-VTEC Sequential Multiport Fuel-injected, 177HP engine K24Z3: 2.4 L DOHC i-VTEC Sequential Multiport Fuel-injected, 190HP engine Serial Number 3000001 -K24Z2 pro ...

    FTP Sensor Replacement
    1. Remove the bolt (A), and disconnect the EVAP canister vent shut valve 2P connector (B), the FTP sensor 3P connector (C), and the hoses (D). 2. Remove the bolts (E), and move the EVAP canister ...