Honda Accord: Accelerator Pedal Module
Removal/Installation - Electronic Throttle Control System - Fuel and Emissions - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Accelerator Pedal Module Removal/Installation

1. Disconnect the APP sensor connector (A).

2. Remove the accelerator pedal module (B).


2. Remove the accelerator pedal module (B).

NOTE: The APP sensor is not available separately. Do not disassemble the accelerator pedal module.

3. Install the parts in the reverse order of removal.

 

    APP Sensor Signal I n s p e c t i o n
    NOTE: - This procedure checks the APP sensor in its fully closed position. In any other position, the APP sensor stores DTCs which are covered in other troubleshooting procedures. - Check for P ...

    VTEC/VTC
    ...

    See also:

    CMP Pulse Plate B Replacement
    1. Remove the cylinder head cover (see page 6-73). 2. Remove camshaft position (CMP) sensor B (see page 11-198). 3. Hold the camshaft with an open-end wrench, then loosen the bolt. 4. Remov ...

    Driveshaft Removal
    Special Tools Required -Ball Joint Thread Protector, 14 mm 07AAE-SJAA100 -Ball Joint Remover, 28 mm 07MAC-SL0A202 1. Raise and support the vehicle, (see page 1-13) 2. Remove the front wheels. 3 ...

    Keys and Locks
    The master key fits all the locks on your vehicle. The valet key works only in the ignition and the driver’s door lock. You can keep the trunk release handle, and glove box locked when y ...