Honda Accord: A/C Refrigerant Oil Replacement - Heating/Air Conditioning - Heating, Ventilation, and Air Conditioning - Honda Accord MK8 2008-2012 Service ManualHonda Accord: A/C Refrigerant Oil Replacement

Recommended PAG oil: DENSO ND-OIL 8

P/N 38897-PR7-A01AH: 120 m l (4 fl-oz)

It is important to have the correct amount of refrigerant oil in the A/C system to ensure proper lubrication of the A/C compressor.

Too little oil damages the A/C compressor; too much oil reduces the cooling capacity of the system, and can produce high vent temperatures.

• To avoid contamination, do not return the oil to the container once dispensed, and never mix it with other refrigerant oils.

• Immediately after using the oil, reinstall the cap on the container, and seal it to avoid moisture absorption.

• Do not spill the refrigerant oil on the vehicle; it may damage the paint ifitgeta on the paint,wash it off immediately.

Add the recommended refrigerant oil in the amount listed if you replace any of the following parts.

A/C condenser

(including Dryer

Desiccant).. 35 mL (1 1/5 fl-oz)

Evaporator 35 mL (1 1/5 fl-oz)

Line or hose 10 mL (1/3 fl-oz)

Leakage repair 25 mL (5/6 fl-oz)

A/C compressor         For A/C compressor replacement, subtract the volume of oil drained from the removed A/C compressor from 82 mL (2 7/9 fl-oz), and drain the calculated volume of oil from the new A/C compressor: 82 mL (2 7/9 fl-oz) — Volume of removed A/C compressor = Volume to drain from new A/C compressor.

NOTE: Even if no oil is drained from the removed A/C compressor, don't drain more than 50 mL (1 2/3 fl-oz) from the new A/C compressor.

A/C Line Replacement


    A/C Service Tips and Precautions
    • Compressed air mixed with the R-134a forms a combustible vapor. • The vapor can burn or explode causing serious injury. • Never use compressed air to pres ...

    A/C Line Replacement
    1.Discharge hose to the A /C compressor (6 x 1.0 mm): S.8 N-m (1.0 kgf-m, 7.2 Ibf-ft) 2.Discharge hose to the A /C condenser (6x1.Р’В© mm): 9.8 N-m f 1.0 kgf-m, 7.2 Ibf-ft) 3.Receiver lin ...

    See also:

    DTC Troubleshooting
    DTC 81152: Gauge Control Module (EEPROM) Error NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see page 22-134). 1. Cle ...

    Connecting Rod Bearing Replacement
    Connecting Rod Bearing Clearance Inspection 1. Remove the oil pump (see page 8-17). 2. Remove the baffle plate (see step 8 on page 7-14). 3. Remove the connecting rod cap and the bearing half. ...

    Clutch Inspection
    1. Inspect the 4th and 5th clutch pistons and the clutch piston check valves (A). 2. If the clutch piston check valve is loose or damaged, replace the clutch piston. 3. Check the spring retain ...