Honda Accord: A/C Compressor Relief Valve
Replacement
1. Recover the refrigerant with a recovery/recycling/charging station (see page 21-80).
2. Raise the vehicle on a lift.
3. Remove the relief valve (A) and the O-ring (B). Plug the opening to keep foreign matter from entering the system, and the A/C compressor oil from running out.
4. Clean the mating surfaces.
5. Replace the O-ring on the relief valve, and apply a thin coat of refrigerant oil before installing it.
6. Remove the plug you installed in step 2, then install and tighten the relief valve.
7. Charge the system (see page 21-81).
A/C Compressor Clutch Overhaul
Special Tools Required
• A/C Clutch Holder Robinair 10290 or Kent-Moore
J37872, commercially available
• A/C Clutch Holder Honda Tool and Equipment
ACT499A, commercially available
1. Re ...
A/C Condenser Replacemen
1. Recover the refrigerant with a recovery/recycling
charging station (see page 21-80).
2. Remove the front grille cover (see page 20-274).
3. Remove the intake air duct and the water separator ...
See also:
Seat Heater Test
Driver's Seat
1. Remove the driver's seat (see page 20-194).
2. Remove the seat back panel.
• 4-door (see page 20-221)
• 2-door (see page 20-213)
3. Disconnect the connector A (4P) ...
To Play a Disc
To load or play discs, the ignition
switch must be in the ACCESSORY
(I) or ON (II) position.
You operate the disc changer with
the same controls used for the radio.
To select the disc changer, ...
Damper/Spring Disassembly, Inspection, and
Reassembly
Exploded View
NOTE: When compressing the damper spring, use a
commercially available strut spring compressor (Branick
MST-580A or Model 7200, or equivalent) according to
the manufacturer's instr ...